TS 72 gaps

(Difference between revisions)
(Test suite: Enable and Disable visualization)
(Test suite: Visualization of correct gaps)
Line 49: Line 49:
# {{testcase|JFrame selected}}
# {{testcase|JFrame selected}}
-
##In main menu select: Tools -> Options
+
##Select "[JFrame]" in Navigator
-
##In Options dilaog select Java category nad GUI Builder tab.
+
#* {{result|EXPECTED RESULT:All gaps are visulaizated. See screenshot in "A many components" test case.  }}
-
##Enable "Visualize Additional Layout Information" checkbox
+
-
## OK
+
-
## Click on JFrame.
+
-
#* {{result|EXPECTED RESULT:The gaps are visualizated again.  }}
+

Revision as of 09:29, 16 August 2012

Form Editor - Gaps Visualization Test Specification

Author: Adam Senk
Version: 7.2
Last update: 16/08/2012
Introduction: Layout of a container in Free Design consists of components and gaps between these components. So far only the components were visualized in the designer, which was sometimes insufficient for a good understanding of the layout. This is improved in NetBeans 7.2 where the gaps are visualized as well.
Comments:

Contents


Test suite: Enable and Disable visualization

Purpose:This is test of checkbox, that turns on/off the visualization of gaps.
Setup: Start IDE with clear userdir. Create new project, Java Application (e.g. MyApplication).In myapplication packege create a new JFrame Form (e.g. MyForm).

  1. Basic visualization
    1. Add a JButton into JFrame
    2. File:Gaps1.jpg
    • EXPECTED RESULT: Gaps are visualizated. See previous screenshot.
  1. Disable visualzition in options dialog
    1. In main menu select: Tools -> Options
    2. In Options dilaog select Java category nad GUI Builder tab.
    3. Disable "Visualize Additional Layout Information" checkbox
    4. OK
    • EXPECTED RESULT: Gaps visilazation disappear.


  1. Reenable gaps visualization
    1. In main menu select: Tools -> Options
    2. In Options dilaog select Java category nad GUI Builder tab.
    3. Enable "Visualize Additional Layout Information" checkbox
    4. OK
    5. Click on JFrame.
    • EXPECTED RESULT:The gaps are visualizated again.

Test suite: Visualization of correct gaps

Purpose:
Setup: Continue with project from previous test case.

  1. A many components
    1. Add some more swing components into JFrame.
    2. File:Gaps2.jpg
    • EXPECTED RESULT: Gaps are visualizated. See previous screenshot.
  1. One selected component
    1. Click on JButton
    2. File:Gaps3.jpg
    • EXPECTED RESULT: Only the neighbour gaps are visualizated.


  1. JFrame selected
    1. Select "[JFrame]" in Navigator
    • EXPECTED RESULT:All gaps are visulaizated. See screenshot in "A many components" test case.
Not logged in. Log in, Register

By use of this website, you agree to the NetBeans Policies and Terms of Use. © 2012, Oracle Corporation and/or its affiliates. Sponsored by Oracle logo